Top Suppliers 788 Bend Pipe for New Zealand Factory
We consistently carry out our spirit of ''Innovation bringing development, Highly-quality ensuring subsistence, Management promoting benefit, Credit attracting customers for Top Suppliers 788 Bend Pipe for New Zealand Factory, With the aim of "compete with good quality and develop with creativity" and the service principle of "take customers' demand as orientation", we will earnestly provide qualified products and good service for domestic and international customers.
***UPDATE INFO 7/13/15*** At the time I made this video I had never had a valve I couldn’t get to reseat in 15 years of refilling these tanks (and I’d refilled a lot of them). But tonight I went out to fill about 15 old 1-pound tanks that someone had brought me and I actually ran into two bad relief valves that would just not seal. Both of them were a bit rusted up and both of them were bone dry with no pressure in them. If I could amend my tutorial I would say that yes, it is possible to have a valve that won’t reseat. You could always just fill it a little bit, then work and check the valves to make sure they will reseal before you fill the small tank all the way. I also found that I could put the tips of the bent nose hemostat down on either side of the pin, grip the valve flats, and gently tighten the valve a little. Leak went away after that.
***Original Description Below***
It can be nearly 700% (and yes, I know I screwed up the % more expensive calculation in the video) more expensive to buy propane in the 1lb bottles than it is to refill them from a BBQ tank using a refill adapter. I cover the economics and then demonstrate how to FULLY refill the standard Coleman 1lb propane cylinders WITHOUT sticking them in the freezer first. This technique is very handy when you’re a week into a camp and need to refill your small cylinder, but didn’t pack your freezer with you.
Mesa Community College, Phoenix East Valley, Arizona.