Factory Wholesale PriceList for Amico high quality Brass stop valve to Cyprus Manufacturer
"Control the quality by the details, show the strength by quality". Our company has strived to establish a highly efficient and stable staff team and explored an effective quality control process for Factory Wholesale PriceList for Amico high quality Brass stop valve to Cyprus Manufacturer, We appreciate your enquiry and it's our honor to work with every friend worldwide.
Doug Donahue from Ewing Irrigation demonstrates the use of a compression coupling to repair broken irrigation PVC pipe.
In this segment I’m going to talk about some of the common products that are used to repair broken PVC pipes. In this case, we have what’s called a bolted repair coupling. This is used to repair large PVC mainlines. Here we have a product called a slip fix. This is a real good product if you have to work in a very tight area, gives you a lot of flexibility with your repair. Here we have a common ¾ inch slip coupling. These can be used for real simple repairs if you’re able to lift the pipe up enough to just use the slip coupling. Here we have the Bell End that is commonly available on PVC pipe. Many times you can use the Bell End as a slip coupling in making a PVC repair.
Here we have a compression coupling. I’m actually going to demonstrate a repair with a compression coupling and talk about the features and benefits of using the compression coupling.
I’m now going to demonstrate how to repair a broken PVC line using what’s called a compression coupling. A compression coupling has a lot of nice advantages. First of all, you don’t have to use any primer or PVC cement to install the compression coupling. Also it doesn’t matter if you have water dripping out the pipe. To make a repair using the compression coupling, we’re first going to unscrew the end. We have the compression end and a gasket inside of it. We’re going to go ahead and install that on 1 end of the pipe and center the compression coupling over your break.
We take the other compression end off and here again we have a gasket inside of there. We’re going to install the compression end on the other piece of the pipe and install our other grommet or gasket. The final component of the compression coupling is the sleeve. We’re now going to center the sleeve over the area where the repair is and then simply tighten the compression ends until they’re tight. That’s all we have to do to make a repair using a compression coupling.