Factory Supplier for PPR-AL-PPR Pipe to Algeria Manufacturer

Short Description:


Product Detail

Product Tags

We pursue the management tenet of "Quality is superior, Service is supreme, Reputation is first", and will sincerely create and share success with all clients for Factory Supplier for PPR-AL-PPR Pipe to Algeria Manufacturer, If you are interested in any of our products or would like to discuss a customized order, please feel free to contact us.


  • Previous:
  • Next:



  • Assembly Instructions for the HD Press

    https://www.hdindustrialdesign.com/products/the-hd-press-200

    Step 1: Install Handle — To install the handle, hand tighten to a snug fit without over tightening.

    Step 2: Install Lid Stops

    Step 3: Install vacuum gauge — hand tighten to a snug fit.

    Step 4: Install Ball Valve — Hand tighten to a snug fit.

    Step 5: Place magnets (small hole side up) on top of screw heads on the front corners and center of the press.

    Step 6: Remove plastic film from membranes. Place silicone on base of press, then line up hinge slots and edges.

    Step 7: After membrane is in place, gently close the lid. Open the lid and the membrane should drape in place.

    Step 8: Simply place the other magnets around the lid and you are done!

    PARTS BREAKDOWN:
    HD Press
    1 Ball Valve with Threaded PVC Fitting
    1 Vacuum Gauge with PVC Elbow and Fitting
    2 Screws
    1 Handle with 2 Screws
    45 Magnets (20 for use, 20 installed, 5 for spares)
    1 Heat Sink
    1 Membrane
    2 Lid Stops

    Do not separate pre-assembled parts. i.e. vacuum gauge and elbow.

    TIP FOR RESETTING MEMBRANE:
    Remove magnets from existing membrane. Align membrane on press base with hinge slots and edges, then roll back edge to place magnets. Once magnets are in place, flip silicone back down and close lid. Place remaining magnets.

    WARNING:
    DO NOT EXPOSE HEAT TO THE ACRYLIC
    DO NOT DRILL OR TAP THE ACRYLIC
    DO NOT CARRY PRESS BY THE LID
    DO NOT PULL VACUUM WITHOUT HEATSINK IN PLACE
    KEEP PRESS AT LEAST 12″ FROM HEAT SOURCE
    (OVEN, HEAT PRESS, ETC.)
    TAKE CARE NOT TO CROSSTHREAD FITTINGS
    DO NOT MOLD DIRECTLY ON VACUUM GRID
    (USE HEAT SINK)
    BE GENTLE WITH MAGNETS



    In this video you will see how a pressure relief valve is used as a brake

    Write your message here and send it to us
    WhatsApp Online Chat !